7.10 S-key
7.10.1 To replace the S-key
The S-key and the receiver card are purchased as a kit.
The 2 units must be replaced at the same time.
1. Open the receiver for the remote control and replace
the receiver card.
2. Turn the key counterclockwise and pull it straight
out.
3. Make sure that the receiver has power and is
started.
4. Push the emergency stop button on the remote
control.
5. Push in the new S-key and turn it clockwise.
6. Turn the emergency stop button clockwise to reset
it.
7. Push and hold down the green button until the green
LED starts to flash slowly.
50 - Repair and servicing 950 - 001 -
To Next Page
Loading...
