HTC DURATIQ T6 - Radial Shaft Seal

7.4 Radial shaft seal
7.4.1 To remove the radial shaft seals
1. Remove the radial shaft seals. Use a screwdriver.
2. Discard the radial shaft seals.
7.4.2 To install the radial shaft seals
1. Put 4 radial shaft seals on top of the holes in the lid.
Note: Make sure that the flat side of the radial shaft
seal points down in the lid. Refer to the picture.
2. Push the radial shaft seals into the holes. Use a
press and a press tool for the radial seals.
Tool number: 593 54 21-01
3. Apply grease.
Use Molykote W2 Multipurpose grease.
34 - Repair and servicing 950 - 001 -