10. Remove the second bearing with a mandrel.
7.8.4 To assemble the secondary pulley
1. Push the bearing into the outer center hub with a
force of 2000 kg.
Tool number: 593 54 09-01
2. Install the snap ring.
3. Install the spacer.
4. Push the bearing with a force of 2000 kg.
Tool number: 595 75 94-01
5. Push the radial seal with a force of 2000 kg.
Note: Make sure that the flat side of the radial shaft
seal points down into the center hub.
Tool number: 593 54 11-01
46 - Repair and servicing 950 - 001 -
To Next Page
Loading...
