EasyManua.ls Logo

HTP SSC-119 - User Manual

Default Icon
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Superstor
Contender
Indirect Fired Water Heaters
Installation
Start-Up
Maintenance
Parts
Warranty
For Residential and Commercial Use
SSC Models
This manual must only be used by a qualied installer / service technician. Read all instructions in this manual before installing.
Perform steps in the given order. Failure to do so could result in substantial property damage, severe personal injury, or death.
The manufacturer reserves the right to make product changes or updates without notice and will not be held liable for
typographical errors in literature.
The surfaces of these products contacted by potable (consumable) water contain less than 0.25% lead by weight as required by
the Safe Drinking Water Act, Section 1417.
NOTE TO CONSUMER: PLEASE KEEP ALL INSTRUCTIONS FOR FUTURE REFERENCE.
272 Duchaine Blvd New Bedford, MA 02745 www.htproducts.com
lp-65 Rev. 002 Rel. 010 Date 10.11.19

Table of Contents

Other manuals for HTP SSC-119

Preview: Installation Start-Up Maintenance Parts
Installation Start-Up Maintenance Parts20 pages
Preview: Installation Manual
Installation Manual16 pages

Questions and Answers

  • B
    Brian DorseySep 8, 2025
    What to do if I have hot tubs, spas, multiple showers, or high demand with my HTP Water Heater?
    • J
      Johnny SmithSep 8, 2025
      If you're experiencing issues with hot tubs, spas, multiple showers, or high demand when using your HTP Water Heater, it could be due to several factors. The pressure might be too low, so check the line pressure for any restrictions. The tank recovery might be slow (slow startup boiler, see chart), or there might not be enough hot water (boiler sized too small, see chart). The demand might also be too great; in this case, check flow rates and compare them to the chart, and consider installing a mixing valve and/or flow restricting valve and raise the tank and boiler temperature.
  • M
    Maria PattersonAug 23, 2025
    What to do if circulator is not operating in my HTP Water Heater?
    • K
      Katelyn WrightAug 23, 2025
      If the circulator is not operating, check or replace it.
  • G
    georgethomasAug 25, 2025
    How to fix air trap in loop of my HTP SSC-119?
    • P
      perkinstaylorAug 25, 2025
      To fix an air trap in the loop, purge the air.
  • S
    Shelia LopezAug 27, 2025
    What to do if water expands when heated in my HTP SSC-119 Water Heater?
    • S
      Scott BoothAug 27, 2025
      If water expands when heated, install an expansion tank.
  • K
    Katrina AndersonAug 27, 2025
    What to do if zone valve fails in my HTP SSC-119 Water Heater?
    • K
      Kristina RhodesAug 28, 2025
      If the zone valve fails, replace the valve.
  • C
    Chad WoodSep 22, 2025
    What to do if the zone valve is not opening on my HTP Water Heater?
    • P
      Patricia SmithSep 22, 2025
      If the zone valve is not opening on your HTP Water Heater, open it manually to replace it.
  • A
    allenfrankSep 16, 2025
    What to do if there is a circulator failure in my HTP SSC-119?
    • M
      Melissa RaySep 16, 2025
      If there's a circulator failure in your HTP Water Heater, replace the circulator.
  • L
    Lisa DavisSep 18, 2025
    What to do if there is a zone valve failure in my HTP SSC-119?
    • T
      Tracey RodriguezSep 18, 2025
      If there's a zone valve failure in your HTP Water Heater, replace the valve.
  • J
    James MorenoSep 7, 2025
    What to do if my HTP SSC-119 has a rotten egg odor?
    • C
      Christopher BarkerSep 7, 2025
      If your HTP Water Heater smells like rotten eggs, it is likely due to the supply water having a high sulfate or mineral content. To address this, check with a water quality specialist in your area and have your water supply analyzed. Then, address any water quality issues according to the specialist’s recommendations.
  • I
    ingrammicheleSep 4, 2025
    What to do if my HTP SSC-119 Water Heater has no hot water?
    • A
      Amy BaldwinSep 4, 2025
      If your HTP Water Heater isn't producing any hot water, several factors could be the cause. These include a zone valve not opening (check or replace), a circulator not operating (check or replace), a tank control set too low (raise tank temperature), a boiler control set too low (raise boiler temperature), incorrect wiring (recheck wiring), a tank control failure (replace control), or an air trap in the loop (purge air).

Summary

Installation

General Safety Information

Essential safety guidelines and warnings for water heater installation.

Prepare the Water Heater

Steps and considerations for preparing the water heater before installation.

Piping

Detailed instructions and requirements for connecting the water heater's piping.

Dimensions and Performance

Technical specifications, performance data, and sizing guidelines for the water heater models.

Applications

Illustrates various system configurations and typical applications for the water heater.

Heater Control and Wiring

Information on the water heater's control system and electrical wiring procedures.

Start-Up

Start-Up and Operation

Step-by-step guide to filling, purging, and initiating the water heater's operation.

Maintenance

Maintenance and Troubleshooting

Procedures for routine maintenance and solutions for common operational issues.

Parts

Replacement Parts

A list of available replacement parts with their corresponding item numbers and descriptions.

Warranty

Limited Warranty

Details the terms, conditions, and coverage period for the water heater's limited warranty.

Owner Responsibilities

Outlines the duties of the owner and installer to maintain warranty validity.

Warranty Exclusions

Lists conditions and circumstances under which the warranty is not applicable.

HTP SSC-119 Specifications

General IconGeneral
BrandHTP
ModelSSC-119
CategoryWater Heater
LanguageEnglish

Related product manuals