HTP SSC-80 - User Manual

Other manuals for HTP SSC-80

Installation Start-Up Maintenance Parts20 pages

Installation Manual16 pages

Questions and Answers

B
bonnie28Sep 8, 2025
What to do if I have hot tubs, spas, multiple showers, or high demand with my HTP SSC-80?
- H
  hernandezandreaSep 8, 2025
  If you're experiencing issues with hot tubs, spas, multiple showers, or high demand when using your HTP Water Heater, it could be due to several factors. The pressure might be too low, so check the line pressure for any restrictions. The tank recovery might be slow (slow startup boiler, see chart), or there might not be enough hot water (boiler sized too small, see chart). The demand might also be too great; in this case, check flow rates and compare them to the chart, and consider installing a mixing valve and/or flow restricting valve and raise the tank and boiler temperature.
J
Jennifer PowellAug 23, 2025
What to do if circulator is not operating in my HTP SSC-80 Water Heater?
- G
  Gary WallaceAug 23, 2025
  If the circulator is not operating, check or replace it.
M
Michael SmallAug 25, 2025
How to fix air trap in loop of my HTP Water Heater?
- J
  jhallAug 25, 2025
  To fix an air trap in the loop, purge the air.
S
Stephen JamesAug 27, 2025
What to do if water expands when heated in my HTP SSC-80?
- R
  Richard McdonaldAug 27, 2025
  If water expands when heated, install an expansion tank.
W
wesleylyonsAug 28, 2025
What to do if zone valve fails in my HTP SSC-80 Water Heater?
- F
  Francisco ReidAug 28, 2025
  If the zone valve fails, replace the valve.
A
alicia69Sep 22, 2025
What to do if the zone valve is not opening on my HTP SSC-80?
- L
  Leroy RichardsonSep 22, 2025
  If the zone valve is not opening on your HTP Water Heater, open it manually to replace it.
R
Robert ThomasSep 16, 2025
What to do if there is a circulator failure in my HTP SSC-80 Water Heater?
- C
  Catherine BlackwellSep 16, 2025
  If there's a circulator failure in your HTP Water Heater, replace the circulator.
M
mreynoldsSep 18, 2025
What to do if there is a zone valve failure in my HTP SSC-80 Water Heater?
- M
  Michelle RobbinsSep 18, 2025
  If there's a zone valve failure in your HTP Water Heater, replace the valve.
P
Patrick GarzaSep 7, 2025
What to do if my HTP SSC-80 has a rotten egg odor?
- H
  hbriggsSep 7, 2025
  If your HTP Water Heater smells like rotten eggs, it is likely due to the supply water having a high sulfate or mineral content. To address this, check with a water quality specialist in your area and have your water supply analyzed. Then, address any water quality issues according to the specialist’s recommendations.
W
William ButlerSep 4, 2025
What to do if my HTP Water Heater has no hot water?
- D
  Debra WarnerSep 4, 2025
  If your HTP Water Heater isn't producing any hot water, several factors could be the cause. These include a zone valve not opening (check or replace), a circulator not operating (check or replace), a tank control set too low (raise tank temperature), a boiler control set too low (raise boiler temperature), incorrect wiring (recheck wiring), a tank control failure (replace control), or an air trap in the loop (purge air).