J
Joseph DavisAug 18, 2025
What to do if my HTP Superstor Ultra SSU CB control is set too low?
- AaguirresamanthaAug 18, 2025
If the control is set too low, raise the control temperature.
To Next PageTo Next PageWhat to do if my HTP Superstor Ultra SSU CB control is set too low?
If the control is set too low, raise the control temperature.
What to do if my HTP Superstor Ultra SSU CB Water Heater tank control is set too low?
If the tank control is set too low, raise the tank temperature.
Why is there not enough hot water from my HTP Superstor Ultra SSU CB?
If you're experiencing a lack of hot water, the boiler might be too small. Refer to the chart for proper sizing information.
What to do if the water pressure is too high in my HTP Water Heater?
If the water pressure is too high, install a pressure reducing valve.
Why is the tank recovery slow on my HTP Superstor Ultra SSU CB Water Heater?
A slow startup boiler may cause the tank recovery to be slow. Refer to the chart for more details.
What to do if my HTP Superstor Ultra SSU CB Water Heater tank temperature is too high?
If the tank temperature is too high, lower the tank temperature.
What to do if the circulator failure in my HTP Superstor Ultra SSU CB?
If the circulator fails, replace it.
What to do if the zone valve failure in my HTP Superstor Ultra SSU CB Water Heater?
If the zone valve fails, replace the valve.
What to do if the tank control failure in my HTP Superstor Ultra SSU CB?
If the tank control fails, replace it.
What to do if the wiring is incorrect on my HTP Superstor Ultra SSU CB Water Heater?
If the wiring is incorrect, check the wiring.
General| Model | SSU CB Series |
|---|---|
| Max Pressure | 150 psi |
| Warranty | Limited Lifetime |
| Material | Stainless Steel |
| Height | Varies by model |
| Diameter | Varies by model |
| Thermostat | Adjustable |
| Tank Material | 316L Stainless Steel |
