12
Installing the BTS3900C Cabinet
d
Installing the BTS3900C Cabinet on a Stand
1. Mark off four fixing points
according to the holes on the stand.
2. Use a percussion drill to drill holes at
the fixing points, and then install
expansion bolt assemblies.
Use a cleaner to clear the dust inside and around
the holes. Then, measure the inter-hole spacing. If
the inter-hole spacing is too wide or too narrow,
locate and drill holes again.
M12x60
3. Place the stand on the holes, and then use expansion bolt assemblies to
install the stand on the ground securely.
Ф16
To Next Page
Loading...
Need help?
General