Connect the power transformer to the power port on the
Conn-x equipment and plug it to the mains socket.
Press the ON/OFF power button located on the side of the
equipment, to turn on your equipment.
The Power, ADSL, Internet, LΑΝ and WLAN LEDs will light.
To connect additional telephone sets to other sockets, each set
must be connected to a lter. Connect your telephone set to the
lter and the lter to the socket.
Note: If your telephone network is connected to any device
(alarm, telephone exchange, etc.), you must use an additional
ADSL lter or splitter. Please contact a specialized installer.
If you have an ISDN telephone line,
connect the ADSL2+ Router
as shown below.
To Next Page
Loading...
