Disconnect the cable that connects the telephone
set to the ISDN equipment (N.T. 1) from the telephone
socket and connect it to the black port on the splitter.
Use the yellow cable to connect the network port (ETHERNET)
of your computer to one of the three rst yellow ports on the
Conn-x equipment.
WARNING: The purple port labeled STB is used exclusively to
connect the set-top-box required to receive OTE's Cable Television
over Internet service.
Connect the power transformer to the power port on the
Conn-x equipment and plug it to the mains socket.
Press the ON/OFF power button located on the side of the
equipment, to turn on your equipment.
The Power, ADSL, Internet, LΑΝ and WLAN LEDs will light.
Note: If your telephone network is connected to any device
(alarm, telephone exchange, etc.), you must use an additional
ADSL lter or splitter. Please contact a specialized installer.
A. Using the blue cable, connect the blue port on the
splitter to the telephone socket.
B. Next, use the grey cable to connect the grey port
on the splitter to the grey port on the Conn-x equipment.
To Next Page
Loading...
