HUAWEI MU736 HSPA+ M.2 Module
Hardware Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7.3 Antenna Plug
Figure 7-2 Mating the plug
1. Align the mating tool or the mating end of the tool over the plug end of the cable
assembly.
2. Firmly place the tool over the plug until it is secured in the tool.
3. Place the plug cable assembly (held in the tool) over the corresponding
receptacle.
4. Assure that the plug and receptacle are aligned press-down perpendicular to the
mounting surface until both connectors are fully mated.
5. Remove the mating tool by pulling it up carefully.
Figure 7-3 Unmating the plug
The extraction tool is recommended.
Any attempt of unmating by pulling on the cable may result in damage and influence the
mechanical / electrical performance.
It is recommended that not to apply any pull forces after the bending of the cable, as
described in Figure 7-4 .
To Next Page
Loading...
