l Do not remove or insert a controller forcibly; otherwise, too much force may cause damage
to the physical appearance or plug-ins.
l When replacing a controller, you must remove the controller and install a new controller
within two minutes.
Procedure
Step 1 Wear an ESD-preventive wrist strap, ESD-preventive gloves, or ESD-preventive clothes.
Step 2 Remove the cable that connects the controller to be replaced.
Step 3 As shown in Figure 6-1, fully open the spring leafs of the controller in the arrow direction and
remove the controller.
Figure 6-1 Remove a controller
Step 4 Put the removed controller into the ESD-preventive bag.
Step 5 Take the controller to be installed from the ESD-preventive bag.
Step 6 As shown in Figure 6-2, insert the controller to be installed in the empty slot, and close the
spring leafs of the controller.
Figure 6-2 Install a controller
6 Replacing Parts
OceanStor S2600 Storage System
Troubleshooting
6-4 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-01-28)
To Next Page
Loading...
