Huawei OceanStor V3 Series

To Next Page

To Previous Page

NOTE

When you create a remote replication task using the storage resources created based on an application,

all available LUNs of the application are displayed in Primary Resource. For details about how to

create storage resources based on applications, see Creating Storage Resources Based on

Applications in the OceanStor V3 Series V300R006 Basic Storage Service Guide for Block. For

OceanStor 2000 V3 series (excluding 2600 V3 Video Surveillance Edition and 2800 V3), 5000 V3

series, and 6000 V3 series, you can configure the storage resources created based on applications. For

OceanStor 18000 V3 series, the storage resources created based on applications are not displayed when

you create a remote replication pair, because this type of storage resources is not supported by

OceanStor 18000 V3 series.

4. Click Next.

Step 5 Select synchronous remote replication primary and secondary resources.

1. From the Remote device drop-down list, select the remote device where the secondary

resource resides.

NOTE

If no remote device exists, click Add to add one.

2. In the Primary Resource area, select the remote replication primary resource.

3. In the Secondary Resource area, select the remote replication secondary resource.

4. Click Add to Pairs.

The selected primary and secondary resources are added to Pairs.

5. Click Next.

Step 6 Set properties of the remote replication pair.

1. On the Set Properties page, set the remote replication parameters based on your service

requirements.

Table 3-5 describes parameters of remote replication.

OceanStor V3 Series

Remote Replication Feature Guide for Block

3 Configuring Remote Replication

Issue 06 (2018-01-30) Huawei Proprietary and Confidential

Huawei OceanStor V3 Series - Page 65