Huawei OceanStor V3 Series User Manual

Configuration
Roadmap
Major
Operation
and Purpose
Planning
Item
Parameter Planned Value
Add a route.
Perform this
step when the
host port on
the primary
storage
system and
that on the
secondary
storage
system use IP
addresses in
different
network
segments. If
the host ports
use IP
addresses in
the same
network
segment, skip
this step.
Information
about the route
list of site A
and that of site
B
l Type
l Destination
address
l Destination
mask
l Gateway
l Site A
– Network
segment
route
– 172.17.0.0
– 255.255.0.
0
– 172.16.0.1
l Site B
– Network
segment
route
– 172.16.0.0
– 255.255.0.
0
– 172.17.0.1
Add a remote
device.
Set up a
logical
connection
between the
primary and
secondary
storage
systems for
remote data
transmission.
NOTE
You only
need to
perform this
step on either
storage
system.
Remote device
information of
the storage
system at site A
or site B
l Link type
l Controller
l Port
l IP address
l Username
l Password
l iSCSI
l CTE0.A
l CTE0.R5.IO
M0.P0
l 172.17.20.31
l The right
username
a
l The right
password
a
OceanStor V3 Series
Remote Replication Feature Guide for Block
4 Configuration Example
Issue 06 (2018-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
81

Huawei OceanStor V3 Series Specifications

General

Supported Protocols	FC, iSCSI, NFS, CIFS
RAID Support	RAID 0, 1, 3, 5, 6, 10, 50
Controller	Redundant, active-active controllers
Cache	Up to several GB per controller
Snapshot	Supported
Replication	Supported
Form Factor	Rack-mountable
Controllers	Dual controllers
Host Interface	8Gbps/16Gbps FC, 1Gbps/10Gbps iSCSI
Drive Types Supported	SSD, SAS, NL-SAS
Operating System	Huawei OceanStor OS
Data Protection	RAID, Snapshot, Replication
Data Services	Thin Provisioning
Management	Web-based GUI, CLI, SNMP
Scalability	Scalable capacity and performance
High Availability	Redundant hardware, hot-swappable components, automatic failover
Power Supply	Redundant power supplies