34
13
Installing E1 Cables
Run the E1 cables into the cabinet through cable holes at the top of
the cabinet.
Run the E1 cables down the rear panel of the cabinet and then
through the cable distribution plate.
Connect the E1 cables to the ports on the interface board and
tighten captive screws for the cable connectors.
Cable hole
Cable
distribution plate
E1 cable
Run the E1 cables into the cabinet through cable holes at
the bottom of the cabinet.
Run the E1 cables up the side panel of the cabinet and then
through the cable distribution plate.
Connect the E1 cables to the ports on the interface board
and tighten captive screws for the cable connectors.
Installing E1 cables - OptiX OSN 9560 and OptiX OSN 3500
a
• Installing E1 cables - overhead cabling
• Installing and routing E1 cables – cabling from the floor
Cable distribution plate
E1 cable
To Next Page
Loading...
