43
1
Attaching Labels
Attaching Engineering Labels
Attaching labels to power cables
a
Attaching labels to signal cables
b
As a general rule, attach labels 2 cm away from cable
connectors.
Identification label
Cable
Attach the identification label
above the cable if cables are
run horizontally.
Attach the identification label to the
right hand side of the cable if cables
are run vertically.
Identification label
Cable
To:
B03 — -48 V2
To:
B03 — -48 V2
If a cable runs vertically, attach labels horizontally on the right hand side; if a cable runs
horizontally, attach labels vertically underneath the cable.
To:
A03-33-33-33-33
Fiber Fiber Fiber
Label
Fold the left part to the right.
Fold the lower part upwards.
NOTE
To Next Page
Loading...
