12
Before installing the chassis in an ETSI cabinet, adjust
the holes for installing mounting ears based on the type
of the cabinet.
Installing the Chassis in the
Cabinet
c
Installing PGND Cables
d
Connect PGND cables by using the removed screws.
Installing Mounting Ears
a b
2
Installing the Chassis in the ETSI Cabinet
Fixing Floating Nuts
Mounting ears
When tightening floating nuts, ensure a minimum of 25
mm space on the left and right sides of the IDU for
ventilation.
2.0±0.2 N·M
M6
1.4±0.14 N·M
M4
3.0±0.3 N·M
M6
Floating nut
Installation hole
To the ground point on the column of the
cabinet or the indoor ground bar
Install the cable tray if provided.
NOTE
NOTE
cable tray
To Next Page
Loading...
