When wall-mounting the chassis, place the fan assembly in the lower part of the chassis for heat dissipation.
Marking and Drilling Holes (2)
g
Drill 8 mm diameter
holes with a depth
ranging from 52
mm to 60 mm.
Place the equipment on the wall and then mark the positions of the holes for installing mounting ears.
Remove the equipment and drill the holes at the marked positions.
Installing the Chassis on the Wall
h
Installing PGND Cables
i
Fan assembly
M6x60 expansion bolt
Nut
Big flat washer
Small flat
washer
PGND cable
Mark the hole positions.
1.4±0.14 N·M
M4
NOTE
To Next Page
Loading...
