PowerCube 500 (CPS300-N18A1H)
User Manual
Copyright © Huawei Technologies Co., Ltd.
Figure 6-3 Removing the old function module (wall-mounted)
5. Loosen the screws on the hanging kit at the rear of the function module and remove the
hanging kit.
Step 4 Install the new function module.
1. Secure the hanging kit to the rear of the new function module and tighten the four
screws.
2. Install the new function module.
3. Connect the cables to the function module based on the recorded information.
4. Use waterproof tape to seal the cable connectors.
Step 5 Switch on the upstream input circuit breaker for the function module.
Step 6 Take off the protective gloves.
----End
Follow-up Procedure
Pack the faulty component and send it to the local Huawei warehouse.
To Next Page
Loading...
