PowerCube 500 (CPS300-N18A1H)
User Manual
Copyright © Huawei Technologies Co., Ltd.
Figure 6-9 Removing the old fuse
As shown in the preceding figure, when the flat-head screwdriver is turned to Open, the flat-head bolt
ejects. Then remove the fuse.
Step 5 Install the new fuse in a reverse order of the removal procedure.
Step 6 Connect the quick connector to the port based on the recorded information.
Step 7 Use waterproof tape to seal the cable connections.
Step 8 Take off the protective gloves.
----End
To Next Page
Loading...
