Figure 5-4 Selecting the terminal type
----End
Follow-up Procedure
After the preceding configurations are complete, press Enter. If the prompt <Quidway> is
displayed on the screen, it indicates that the Command Line Interface (CLI) is displayed. In this
case, you can enter commands to configure or manage the S2700/3700/5700/6700. For details
on configuration procedures, see the following sections.
5.2 Example for Configuring to Manage the SwitchThrough
Telnet
Networking Requirements
As shown in Figure 5-5, SwitchA is newly added to the network. SwitchA and SwitchB are
connected through a trunk link. To enable the network administrator to manage SwitchA
remotely, you need to configure the Telnet service and set the device name on SwitchA.
Quidway S2700&S3700&S5700&S6700 Series Ethernet
Switches
Quick Start 5 Logging in to the Device
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
50
To Next Page
Loading...
