Huawei Quidway S2700 series - Configuration Procedure

Figure 5-5 Networking diagram of managing SwitchA through Telnet
RS-232
Console cable
Console port
PC SwitchA
serial port
Ethernet
administrator
SwitchB
GE 0/0/1
GE 0/0/1
Configuration Roadmap
The configuration roadmap is as follows:
l Log in to SwitchA through the console interface.
l Set the device name.
l Configure a management VLAN.
l On SwitchA, set the type of the interface that connects SwitchA and SwitchB to trunk. Add
the interface to the management VLAN in trunk mode.
l Configure the management IP address of SwitchA.
l Configure the Telnet service.
Data Preparation
To complete the configuration, you need the following data:
l ID of the management VLAN
l Management IP address of SwitchA
l Number of the interface that connects SwitchA and SwitchB on SwitchA
l Authentication mode, user name, and password
Configuration Procedure
1. Log in to SwitchA through the console port. For details, see Logging In to the Switch
Through the Console Interface
.
2. Set the device name of SwitchA.
<Quidway> system-view
[Quidway] sysname SwitchA
3. Configure a management VLAN.
[SwitchA] vlan 1
Quidway S2700&S3700&S5700&S6700 Series Ethernet
Switches
Quick Start 5 Logging in to the Device
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
51