Huawei R100030G1 - Connecting AC Input Power Cables

● Output connector with crimped cables on signal pins: Crimp the
communications cable (prepared by the customer), connect the cable to the
metal socket, and then insert the cable into the corresponding pin of the
output connector.
Figure 4-7 Connecting DC output cables and signal cables (welded)
Figure 4-8 Connecting DC output cables and signal cables (crimped)
----End
4.4.2 Connecting AC Input Power Cables
● The metal socket is delivered with the AC input connector.
● Check whether the metal socket is reliably crimped. The minimum pull-out
force is 400 N for 8 AWG cables or cables with a cross-sectional area of 10
mm
2
.
● The front end of the heat-shrink tubing should not exceed the scale on the
metal socket. The outer diameter of the metal socket covered with the heat-
shrink tubing is less than or equal to 7.5 mm.
R100030G1 Charging Module
User Manual 4 Installation
Issue 05 (2021-11-16) Copyright © Huawei Digital Power Technologies Co., Ltd. 28