Figure 11-3 Stripping the specified length of the sheath and shield layer
Step 3 Strip the sheath off each core wire, as shown in Figure 11-4.
Figure 11-4 Stripping the sheath off each core wire
Step 4 Add OT terminals to two core wires, as shown in Figure 11-5.
Figure 11-5 Adding OT terminals
Step 5 Strip about 15 mm (0.59 in.) of the sheath off the power cable to expose the intact shield layer,
as shown in Figure 11-6.
Figure 11-6 Stripping the specified length of sheath
----End
RRU3201
Installation Guide 11 Appendix
Issue 06 (2012-04-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
88
To Previous Page
