Huawei RRU3269 - Installing the RRU on a Pole; Installing a Single RRU

RRU3269
Installation Guide
8 Installing the RRU
Issue Draft B (2018-05-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
51
8.2 Installing the RRU on a Pole
One or more RRUs can be installed on a pole.
8.2.1 Installing a Single RRU
This section describes the procedure and precautions for installing a single RRU on a pole.
Prerequisites
Before you install an RRU on a pole secured on a tower, the RRU and its mounting kits are
hoisted onto the tower. For details, see 7.1 Hoisting an RRU onto a Tower.
The hoist clamp on the main bracket is secured properly.

Do not stand an RRU upright because the RF ports cannot support the weight of the RRU.

Place a foam pad or cardboard under an RRU to protect the RRU housing from damage
during the installation.
Procedure
Step 1 Determine a position for installing the mounting kits.

If the RRU is installed on a tower, determine a position for installing the mounting kits
according to the instructions in 3.5.1 Clearance for a Single RRU.

If the RRU is installed on the ground, determine a position for installing the mounting
kits according to Figure 8-3.