RRU3269
Installation Guide
Issue Draft B (2018-05-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Prerequisites
The hoist clamp on the main bracket is secured properly.
Do not stand an RRU upright because the RF ports cannot support the weight of the RRU.
Place a foam pad or cardboard under an RRU to protect the RRU housing from damage
during the installation.
Procedure
Step 1 Install the first RRU onto the main bracket, as shown in Figure 8-8. For details, see 8.2.1
Installing a Single RRU.
Figure 8-8 Installing the first RRU onto the main bracket
Step 2 Use an M6 inner hexagon screwdriver to loosen the four hex socket screws from the main
bracket and pole mounting kit on the second set of mounting kits, and remove the main
bracket, as shown in Figure 8-9.
To Next Page
Loading...
