Connecting to the Inverter over the App
Step 1 Ensure that the Smart Dongle to be upgraded is inserted into a running inverter.
Wait for more than 2 minutes, remove the Smart Dongle, and connect the WLAN
module, Bluetooth module, or USB data cable to the inverter.
Perform this step if communication with the inverter over a WLAN module, Bluetooth
module, or USB data cable is required.
Step 2 Run the FusionSolar app and go to the Device commissioning screen. (Perform
this step only for the FusionSolar app.)
Figure 6-12 Device commissioning
Step 3 Connect to the inverter.
Figure 6-13 Connecting to the inverter
FusionSolar Smart PV Management System
Connection
User Manual (Inverters + SDongleA) 6 Maintenance
Issue 02 (2021-11-25) Copyright © Huawei Technologies Co., Ltd. 58
To Next Page
Loading...
