Huawei SUN2000-20KTL - Enabling Manual Power-On and Power-Off

SUN2000 (8KTL-28KTL)
User Manual
7 LCD
Issue 07 (2014-07-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
96
LCD
Operation Procedure
3. Enter the user name and password by
pressing or , and press .
NOTE

The selectable user names are Common User
and Advanced User. The initial password for
Common User and Advanced User is 000001.
If you forget the password, contact Huawei
technical support for a dynamic password that is
effective only on the current day. Change the
password after login.

After the authentication is successful, the
system keeps the authentication information for
30 seconds. If you exit from the Settings page
and log in again within 30 seconds, no
authentication is required.
4. Choose Isolation and press .
5. Select one isolation method, and press .
----End
7.2.12 Enabling Manual Power-On and Power-Off
This topic describes how to enable manual power-on and power-off on the monitoring panel.
Procedure

The following table describes the procedure for enabling manual power-on and
power-off. The parameter values in the figures are for reference only.
LCD
Operation Procedure