Huawei SUN2000-33KTL - Page 5

4
1. Remove the two screws from the maintenance compartment door using a hex key and set them
aside.
1. Obtain the hex key and reserved screws
from the fitting bag bound to the reinforcing
rib at the chassis base.
2. Do not leave unused screws in the chassis.
3. Do not open the host panel of the inverter.
4. Before opening the maintenance
compartment door, switch off the
downstream AC output circuit breaker and
DC SWITCH.
NOTICE
2. Open the maintenance compartment door and
install the support bar available in the fitting bag
bound to the reinforcing rib at the chassis base.
3. Remove the AC terminal cover.
4. Remove an appropriate length of the jacket and insulation layer from the AC output cable using
a wire stripper.
a. SUN2000-33KTL/33KTL-E001
(excluding the ground cable)
c. SUN2000-30KTL-A/40KTL (excluding
the ground cable)
b. SUN2000-33KTL/33KTL-E001 (including
the ground cable)
d. SUN2000-30KTL-A/40KTL (including the
ground cable)
JacketInsulation layer
Core wire