12
4. Choose Maintenance > Device replacement and select a device replacement type to replace
or restore the protocol.
5. (Optional) If you need to set other parameters, tap Settings.
By default, Device
replacement is set
to None. Restore the
SUN2000-(8KTL–
12KTL)-M2 protocol.
Select a model for device
replacement, set the grid
code, time zone, time, and
communication address,
and complete the protocol
replacement.
Default Settings of
Device Replacement
Model Selection for
Device Replacement
Before replacing SUN2000-(8KTL–12KTL) with SUN2000-(8KTL–12KTL)-M2, you must replace
the protocol. Otherwise, SUN2000-(8KTL–12KTL)-M2 cannot connect to the management
system.
To Next Page
Loading...
