Huawei TE30 - Page 13

13
Parameter
Description
Setting
Enable GK
Whether to register your TE30 with the
network gatekeeper (GK).

If you select this parameter, the
TE30 registers with the GK after
being started. After successfully
registering with the GK, the TE30
can call endpoints defined in the
address book by their IP addresses,
numbers, and names.

If you do not select this parameter,
the TE30 does not register with the
GK and can call endpoints only by
their IP addresses.
By default, this parameter is
deselected.
Site number
Site number for the TE30.
If the TE30 has registered with the GK,
other endpoints can call the TE30 by
this number.
The site number can contain
only digits.
Example: 12345
H.323 ID
Name by which the GK identifies the
TE30 after it registers with the GK.
The name consists of digits,
letters, and special characters,
such as @ # %.
Example: ab3@Joe
Authenticatio
n user name
User name for H.323 authentication.
Ensure that this user name is the same
as that predefined on the GK.
Otherwise, the GK fails to authenticate
the TE30.
Obtain this user name from
your network service provider.
Password
Password the TE30 uses to register with
the GK.
Ensure that this password is the same as
that predefined on the GK. Otherwise,
the GK fails to authenticate the TE30.
Obtain this password from your
network service provider.