9
Powering On the TE30
With all cables connected correctly, use the power adapter to connect the TE30 to a power supply.
When the power adapter indicator turns on, the TE30 automatically powers on and the Wizard
screen is displayed.
If the HDMI port is used for video output, after you set the parameters on the Wizard screen, the
menu screen is displayed.If the VGA OUT port is used for video output, perform the following
steps to access the menu screen. Press and hold on the remote control for 5 seconds.
1 The following table describes the TE30 indicator status.
Powered off but connected to
the power supply
Disconnected from the power
supply
Encountered a fault, such as a
self-check error, overheating,
and software malfunction
Loading the Configuration File
The TE30 automatically loads the configuration file on a USB device, such as a USB flash drive.
After the configuration file is loaded, the TE30 works properly. If no USB device is available,
load the configuration file on the Wizard screen.
Using a USB Device
The endpoint automatically loads the configuration file on a USB device, such as a USB flash
drive. After the configuration file is loaded, the endpoint should work properly.
The USB device is provided by your operator or Huawei's reseller or service engineers. Huawei's
service engineers provide the configuration file, which you must not modify unless requested to
do so.
Caution
Before loading a configuration file on a USB device, scan the device for viruses.
To load the configuration file on the USB device:
Do not turn the TE30 or stop it from turning using your hands or other
forces when the TE30 is powered on and working properly.