HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Specifies the percentage of the call
bandwidth presentations can occupy.
Specifies the mode of the presentation
you want to share.
Presentation: When the video is
switched, the presentation remains
unchanged. Only one site in the
conference can share a presentation
one time.
Live: The presentation viewed by
each site is switched along with the
video. All sites in a conference can
share presentations simultaneously.
NOTE
When connected to an IMS network, the
endpoint cannot share a presentation in Live
mode.
The default value is
Presentation.
Presentation
sharing mode
Auto: The endpoint automatically
shares presentations along with
videos. This parameter can be set to
Auto only when Presentation mode
is set to Live.
Manual: You must manually share
presentations by using the remote
control.
The default value is
Manual.
Presentation
plug-and-share
Specifies whether your site
automatically shares presentations with
remote sites once presentation input is
detected.
The default value is Disable.
Specifies the type of line used during a
conference.
If you select Auto and your endpoint has
registered with a network gatekeeper
(GK) server, your endpoint
preferentially uses H.323 to initiate a
conference.
The default value is Auto.
Specifies the transmission bandwidth for
a conference.
The default value is Normal.
Specifies whether the endpoint
implements the following if the packet
loss rate increases due to insufficient
network bandwidth: automatically
decreases the conference bandwidth
until packet loss does not occur
constantly or the conference bandwidth
is decreased to 64 kbit/s. If constant
This parameter is not
selected by default.
When the network is
running within normal
parameters, retain the
default value.
When the network is not
To Next Page
Loading...
