Huawei TE80 - Using the Wizard

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
2 Basic Configuration and Verification
Issue 02 (2014-03-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12
Table 2-2 Alarm indicator description
When the Alarm Indicator
Is...
The Endpoint Is...
Blinking red twice per second
Overheated.
Blinking red four times per
second
Encountering a temperature fault. For example, the
temperature sensor inside the endpoint cannot sense the
current operating temperature, causing fast fan rotation
speed and loud fan noise.
2.2 Using the Wizard
The Wizard helps you quickly set the general, network, and camera parameters on your
endpoint.
Background
When configuring the endpoint for the first time, you can connect to the NMS server to
configure the endpoint. If the NMS server has not been configured or obtaining the NMS
server settings times out, perform the steps in this section to set the required parameters.
If a USB flash drive is provided with your endpoint, you can also load the configuration file
from the USB flash drive to configure your endpoint.
Procedure
Step 1 Choose Advanced > Settings > Installation > Wizard.
The General screen is displayed.
Step 2 Set the general parameters described in Table 2-3 and Table 3-3.
Table 2-3 General parameters
Parameter
Description
Setting
Sites
Specifies the name of your site. The site
name is superimposed on the local video.
When your site joins a multipoint
conference, this site name is displayed in
the site list.
Default value: site
Language
Specifies the language for the remote
controlled UI.
Default value: English
Time zone
Specifies the time difference between the
local time and the Greenwich Mean
Time (GMT).
The endpoint automatically sets this
parameter based on the country or region
Default value: