Huawei TE80 - Page 24

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
2 Basic Configuration and Verification
Issue 02 (2014-03-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16
Parameter
Description
Setting
specified time.
NOTE
If you enable this function, you
must also set Scheduled power-on
time (hh:mm).
Scheduled
power-on time
Specifies the time when the
endpoint automatically powers
on.
The value format depends on the
value set for Time format.
The default value is 0:0, which
corresponds to the 24-hour value
for Time format.
Scheduled
power-off
Specifies whether the endpoint
automatically powers off at the
specified time.
NOTE
If you enable this function, you
must also set Scheduled power-off
time (hh:mm).
This parameter is not selected by
default.
Scheduled
power-off time
Specifies the time when the
endpoint automatically powers
off.
The value format depends on the
value set for Time format.
The default value is 0:0, which
corresponds to the 24-hour value
for Time format.
Step 2 Select Save.
The endpoint enters sleep mode, and the LED indicator blinks purple once every 2 seconds.
----End
To directly place the endpoint in sleep mode, press on the remote control and select Sleep.
Follow-up Procedure
The endpoint wakes up from sleep mode in response to any of the following conditions:

You use the touch panel.

An endpoint upgrade starts.

A presentation source is connected to the endpoint.

The camera forwards infrared signals to the endpoint.

The WOL function is used.

The clock matches the scheduled endpoint startup time.

The endpoint receives a call.

You use the remote control.

You log in to the endpoint web interface.