Huawei TE80 - Page 28

HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
3 Network
Issue 02 (2014-03-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
20
Parameter
Description
Setting
same time.

1000Mbps and full duplex: The data
transmission rate is 1000 Mbit/s, and
data can be sent and received at the
same time.
Hub
network port
mode
The endpoint can function as a hub in
this mode, enabling the devices
connected to its two network ports to
communicate with each other.
When the endpoint is connected to the
Internet, devices connected to the
network ports on the endpoint can also
access the Internet.
The default value is Disable.
Connection
type
Specifies the mode in which the
endpoint obtains an IP address.

Static IP: The network administrator
assigns an IP address to the endpoint.
If you select this option, you must
also set Local IP address, Subnet
mask, and Gateway address.

Dynamic IP: When a DHCP server
is available on the network, the
endpoint automatically obtains an IP
address using the Dynamic Host
Configuration Protocol (DHCP).
The default value is Static IP.
Local IP
address
Specifies the endpoint IP address.
The default value is 192.168.1.1
Examples:

IPv4: 192.168.1.10

IPv6:
2000:0:0:0:200:55:26:1
Obtain the IP address from the
network administrator.
Subnet mask
Specifies the subnet mask for the
endpoint IP address. A subnet mask
divides the IP address into a network
address and a host address.
The default value is
255.255.255.0
Obtain the subnet mask from
the network administrator.
Gateway
address
Specifies the gateway address that
corresponds to the endpoint IP address.
Examples:

IPv4: 192.168.1.1

IPv6: 2000:0:0:0:200:55:0:1
Obtain the gateway address
from the network administrator.
IPv6
If you select IPv6, you must also set
Connection type, Local IP address,
Subnet prefix length, and Gateway
address.
This parameter is not selected
by default.