Figure 1-36 Battery neutral wire
Step 6 Install communications cables.
1. If you need to log in to the WebUI of the UPS monitoring system, connect the
network port on a PC to the FE port on the monitoring interface card.
2. If the UPS needs to connect to an external network management device,
connect the external network management device to the RS485 port on the
monitoring interface card.
Figure 1-37 Cable route
(1) Communications cable route
----End
UPS5000-A-(30 kVA–120 kVA)
Quick Guide 1 Installation
Issue 14 (2022-09-06) Copyright © Huawei Digital Power Technologies Co., Ltd. 32
To Next Page
Loading...
