Huawei UPS5000-E Series - 1.5 Mechanical Safety

17
10
Exporting Alarms to a USB Flash Drive
11
Appendix
System Configuration Attributes and Values
Item
Value
Description
Rated
operating
voltage
208 V/120 V; 220 V/127 V; 230 V/132 V The default value is 208 V/120 V. Set the
parameter based on site requirements.
Rated
frequency
50 Hz; 60 Hz The default value is 60 Hz. Set the
parameter based on site requirements.
Number of
Phases
LN1
Single phase; three-phase four-wire;
three-phase three-wire
The default value is three-phase four-
wire. Set the parameter based on site
requirements.
Number of
Phases
LN2
Single phase; three-phase four-wire;
three-phase three-wire
The default value is three-phase four-
wire. Set the parameter based on site
requirements.
Secondary
load
Not Used; Opening Only; Opening And
Closing
The default value is Not Used. Set the
parameter based on site requirements.
Generator
Usage
No Generator; Generator In Use The default value is No generator. Set
the parameter based on site
requirements.
Line
Priority
Line 1–Switch I; Line 2–Switch II; No
Priority
The default value is Line 1–Switch I. Set
the parameter based on site
requirements.