Huawei V200R001C01 - Page 106

create time = 2007/11/28 14:04:21, status =
ACTIVE
encapsulation = ietf, vlink = 2, broadcast
– If no mapping is generated, configure the mapping between the PVC and peer
address.
– If the mapping has been generated, go to step 6.
6. Check that both ends have reachable routes to each other.
Run the display fib command to check the routing table.
[Huawei-MFR0/0/0]display this
#
interface
MFR0/0/0
ip address 5.5.5.2
255.255.255.0
return
[Huawei-MFR0/0/0]display
fib
Route Flags: G - Gateway Route, H - Host Route, U - Up
Route
S - Static Route, D - Dynamic Route, B - Black Hole
Route
-------------------------------------------------------------------------
-----
FIB
Table:
Total number of Routes :
17
Destination/Mask Nexthop Flag TimeStamp Interface
TunnelID
5.5.5.1/32 5.5.5.1 HU t[2082] MFR0/0/0
0x0
5.5.5.255/32 127.0.0.1 HU t[1025] InLoop0
0x0
5.5.5.2/32 127.0.0.1 HU t[1025] InLoop0
0x0
50.1.1.255/32 127.0.0.1 HU t[545] InLoop0
0x0
50.1.1.1/32 127.0.0.1 HU t[545] InLoop0
0x0
192.168.0.255/32 127.0.0.1 HU t[501] InLoop0
0x0
192.168.0.23/32 127.0.0.1 HU t[501] InLoop0
0x0
6.6.6.255/32 127.0.0.1 HU t[496] InLoop0
0x0
6.6.6.2/32 127.0.0.1 HU t[496] InLoop0
0x0
255.255.255.255/32 127.0.0.1 HU t[487] InLoop0
0x0
127.255.255.255/32 127.0.0.1 HU t[487] InLoop0
0x0
127.0.0.1/32 127.0.0.1 HU t[487] InLoop0
0x0
127.0.0.0/8 127.0.0.1 U t[487] InLoop0
0x0
6.6.6.0/24 6.6.6.2 U t[496] VT3
0x0
192.168.0.0/24 192.168.0.23 U t[501] GE0/0/0
0x0
Huawei AR2200-S Series Enterprise Routers
Troubleshooting 5 WAN
Issue 01 (2012-01-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
97