Relevant Logs
None
5.8.2 Packets Fail to Be Forwarded on a G.SHDSL Interface Working
in ATM Mode
This section provides a troubleshooting flowchart and a step-by-step troubleshooting procedure
to use when packets fail to be forwarded on a G.SHDSL interface working in ATM mode.
Common Causes
This fault is commonly caused by one of the following:
l The cable is not properly connected to the interface or the interface is shut down.
l The local and remote G.SHDSL interfaces are using different transmission standards.
l The local and remote G.SHDSL interfaces are working in different PSD modes.
Troubleshooting Flowchart
Figure 5-13 shows the troubleshooting flowchart.
Huawei AR2200-S Series Enterprise Routers
Troubleshooting 5 WAN
Issue 01 (2012-01-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
127
To Next Page
Loading...
