Huck 2624HS - Page 13

13
2624 & 2630 Series Hydraulic Installation Tools (HK1052) Alcoa Fastening Systems & Rings
asseMbly drawIng 2624ptd
501731
Setscrew
131040 Trigger
Switch Assembly
125691 Back-up Ring
500862 O-Ring
122769-2
GLYD Ring
125682 Front Gland
507417
Polyseal
500862
O-Ring
125691
Back-up
Ring
125683 Wiper Housing
506001 Wiper Seal
126108
Cylinder
Assembly
Piston 127224-1
100248
Retaining
Sleeve
100247
Split Ring
12804
7 End Cap
127286 Dump Valve
505344-4
Strain Relief
506159 Retaining Ring
122762 Spacer
506160
Polyseal
500062
Screw (3)
505894 Wiper Seal
131190 Barbed Retainer
131084 Piston Guard
131079 Pintail Bottle
122764 Locking Disk
NOTE:
Install Pintail Bottle
with Wear Plate
positioned exactly
as shown.
131191 Wear Plate
SEE NOTE BELOW
131192
Washer
508810
EXTERNAL
Retaining
Ring
See Figure 13 for Hose and Cord details.
fIgure 10
2624PTD ASSEMBLY INSTRUCTIONS CONTINUED FROM PAGE 11, INSTRUCTION 11:
After installing End Cap and Wiper Seal, assemble Wear Plate inside Pintail Bottle
exactly as shown, with Washer and Retaining Ring outside Bottle.
Place Piston Guard into Barbed Retainer, and seat both over rear of Piston, as shown.
Secure Retainer and Guard in place with 3 Screws.
Press Pintail Bottle over Barbed Retainer until it seats on back of tool cylinder.