Need help?Do you have a question about the Hudson Boat and is the answer not in the manual?
Information on original manufacturing specifications and codes for the boat.
Guidance on insuring your rowing boat, recommended brokers, and coverage details.
Two methods of transporting the boat: car top and trailer, and preparation steps.
Lists necessary tools for rigging and assembly, including wrenches, tape measures, and levels.
Identifies components of the foot assembly, including toe bar, stretcher, and bolts.
Details the components of the seat assembly, including the seat top, furk, and axle.
Explains the components of the boat's slides and the slide bolt removal process.
Identifies parts of the sweep rigger, including the oarlock, pin block, and angle mount.
Instructions on adjusting foot angle (rake) using bolts and hairpin for optimal rower comfort.
Method for measuring and adjusting foot height from seat to shoe heel cup for consistent feel.
Guidance on setting foot position on tracks for sculling and sweep rowing in the finish position.
Recommendations for initial rigger placement, aligning with the bulkhead for balanced weight distribution.
Step-by-step instructions for mounting riggers for sculling and sweep configurations.
Instructions for adjusting sculling spread using factory stickers or measurements.
Method for adjusting the span in a sweep boat using measurements across the gunnel.
Recommendations for protecting the boat's decks and hull using automotive wax.
How to measure height and depth dimensions for sweep riggers using a level floor.
How to measure height and depth dimensions for sculling riggers using a level floor.
To Next Page
General