Humanscale efloat GO - Hand Switch Advanced Settings; Setting LED Retracted Height; Setting Height Limits

17
5� Hold the DOWN button down while the desk lowers a little bit more, slightly rises and stops�
One-Touch / Constant-Touch
Follow the steps below to change between One-Touch and Constant - Touch� One-Touch requires only
a single touch of the “1, 2 or 3” button to move the worksurface to a preset memory location� One-
Touch is the default setting. Constant-Touch requires a continuous touch of the “1, 2, or 3,” but ton to
move the worksurface to a preset memory location�
1� Press the DOWN button, moving the desk to its lowest position, then release�
2� Hold the DOWN button again, until the LED display reads “ “�
3� Hold the 1 button (about 5 seconds) to switch settings� Repeat until desired setting is
displayed�
10�1 = One-Touch
10�2 = Constant-Touch
4� Once the chosen setting is displayed, wait 5 seconds for the display to return to “ “�
5� Hold the DOWN button while the desk clicks lower, slightly rises and stops�
Setting LED Retracted Height
Press and hold the DOWN button until the worksurface reaches its lowest position� Measure the
distance from the oor to the top surface of the desktop� If the number on the LED display does NOT
match your measurement, follow these steps:
1� Hold the DOWN button again, until the LED display reads “ “�
2� Hold the M button (about 5 seconds) until the display starts ashing the height�
3� Use the UP/DOWN button to match your measurement�
4� Wait 5 seconds for the display to return to “ “�
5� Hold the DOWN button while the desk clicks lower, slightly rises and stops�
Setting Upper and Lower Limits
This desk is designed to go to its minimum and maximum heights, allowing for the longest possible
range� If you prefer to change the settings to a more shorter range, follow these steps:
To Set the Upper-Limit Position:
1� Use the UP /DOWN buttons to move the base to the desired maximum-height position�
2� Press the “M” button�
3� Press the UP button� The LED display will ash “S -”�
4� Hold the “M” button (about 2 seconds) until the LED display changes to “999”� The display will