To install a step:
1. Before installing the bolts:
• Remove all traces of the original adhesive
patch.
• Clean the threads of the bolts with
denatured alcohol or equivalent and allow
threads to dry.
•
Apply Threadlocker (GM Part No. 12345382,
in Canada 10953489) or equivalent.
2. Install the side step to the vehicle. You may
need someone to assist you in the installation.
3. Install the nuts and bolts for the two
inner brackets first, but do not tighten them.
4. Using a level, make sure the step is level in
relationship to the vehicle. Then, tighten the
inner bracket nuts and bolts.
5. Install the other nuts and bolts. Tighten all
nuts and bolts to 39 lb ft (50
Y).
Driving at Night
Night driving is more dangerous than day driving.
One reason is that some drivers are likely to
be impaired — by alcohol or drugs, with night
vision problems, or by fatigue.
Here are some tips on night driving.
• Drive defensively.
• Do not drink and drive.
• Adjust the inside rearview mirror to reduce the
glare from headlamps behind you.
• Since you cannot see as well, you may need
to slow down and keep more space between
you and other vehicles.
• Slow down, especially on higher speed roads.
Your vehicle’s headlamps can light up only so
much road ahead.
• In remote areas, watch for animals.
• If you are tired, pull off the road in a safe
place and rest.
342
To Next Page
Loading...
Need help?
General
