2. Pull the end cap
straight out from the
crossrail.
3. Peel back the rub strip from the crossrail.
4. Slide the accessory you are using into
the crossrail channel and secure it as
the accessory instructions direct.
5. Place the crossrail endcap back on and lock it
with the key.
You will not be using the rub strip when using
crossrail accessories. When you remove any
crossrail accessory, be sure to reinstall the rub
strip. To do this, press the rub strip in place until it
seats into the channel of the crossrail.
Rear Seat Armrest
Your vehicle is equipped with a rear
armrest/cupholder.
To open it, pull up and then out on the tab,
located at the top center of the armrest, and pull
the armrest down.
164
To Next Page
Loading...
Need help?
General
