What to do if HunterDouglas Duette shade will not stay up?
If your HunterDouglas Indoor Furnishing shade will not stay in the raised position, engage the cordlock by pulling the cord toward the outside of the shade to lock it in place.
Why HunterDouglas Indoor Furnishing shade will not fit into the installation brackets?
If the shade won't fit into the installation brackets, check that the installation brackets are level and aligned. If needed, use shims to level the headrail. Ensure the screws' heads are flush against the installation bracket, and that the headrail is fully inserted into the installation brackets.
How to rethread the ferrule on HunterDouglas Indoor Furnishing?
To rethread the ferrule on your HunterDouglas Indoor Furnishing, thread the end of the cord into the tapered end of the ferrule. Loop the cord around the ferrule and back through the tapered end, ensuring the loop fits into the groove on the side of the ferrule.
How to shorten the tassel cord length of HunterDouglas Duette?
To shorten the tassel cord length on your HunterDouglas Indoor Furnishing, slide the tassel up the cord to reveal the knot. Make a new knot below the tassel at the desired location, then trim the excess cord below the knot. Finally, slide the tassel back down over the knot.
How to adjust the length of HunterDouglas Duette shade?
To adjust the height of your HunterDouglas Indoor Furnishing shade, locate the ferrule seated in a pocket on the underside of the bottom rail. Remove the ferrule from the pocket by pulling on the excess cord. To shorten the cord, hold it tight under the ferrule and slide the ferrule up toward the pocket. To lengthen the cord, hold the cord tight between the pocket and the ferrule, then slide the ferrule away from the pocket. After adjusting, place the ferrule fully back into the pocket. You can tape the extra cord length to the bottom rail or place it into the groove on the bottom rail for future adjustments.
How do I re-thread the ferrule on HunterDouglas Indoor Furnishing?
To re-thread the ferrule on your HunterDouglas Indoor Furnishing, thread the end of the cord into the tapered end of the ferrule. Loop the cord around the ferrule and back through the tapered end, ensuring the loop fits into the groove on the side of the ferrule.
What to do if HunterDouglas Indoor Furnishing shade does not raise and lower evenly?
If your HunterDouglas Indoor Furnishing shade doesn't raise and lower evenly, check the installation brackets. Also, ensure that the shade fabric is not caught between the bracket tab and the headrail.
General| Brand | HunterDouglas |
|---|---|
| Installation | Inside mount, outside mount |
| Material | Fabric |
| Light Control | Varies from sheer to opaque |
| Operating Systems | PowerView Automation |
| Specialty Shapes | Yes |
| Style | Modern |
| UV Protection | Up to 99% |
| Light Control Options | Sheer, semi-sheer, semi-opaque, opaque |
| Operation | Manual or motorized |
| Customization | Fabric, Color, Opacity, Operating System |
| Energy Efficiency | Excellent; cellular design traps air for insulation |
To Next Page