HunterDouglas LiteRise - Tools and Fasteners Needed; Unpack the Blind

GETTING STARTED
3
Thank you for purchasing Hunter Douglas horizontal blinds. With proper installation,
operation, and care, your new blinds will provide years of beauty andperformance.
Please thoroughly review this instruction booklet and the enclosed packing list before
beginning the installation.
Tools and Fasteners Needed
■
Ballpoint pen
■
1
⁄ 4 " hex , Flat blade and Phillips screwdrivers
■
Level (laser level is recommended)
■
Measuring tape and pencil
■
Power drill,
3
⁄ 32 " drill bit, and
1
⁄ 4 " hex driver
In addition, you will need fasteners designed to work with your specific mounting surface(s).
■
#6 Hex Head Screws (Provided). Two 1
1
⁄ 2 " screws are provided per installation bracket.
■
Longer #6 Hex Head Screws (Not Provided). If using spacer blocks, use #6 screws
long enough for a secure attachment.
■
Nuts and Screws (Provided). Extension brackets come with nuts and screws.
■
Self-Tapping Screws (Not Provided). If using extension brackets, use self-tapping
screws for a secure attachment.
Unpack the Blind
■
Remove the blind from the package. Keep the packaging
until the blind operates to your satisfaction.
■
Refer to the packing list and check for all necessary parts.
■
Contents of your hardware package may vary
depending upon the options chosen.
■
Do not remove the slat protector tape (if applied).
Doing so will damage the slat finish.
■
Remove shipping protective piece in the headrail
before installing (if applied).
Nut
and Screw
(Two Provided with
Each Extension Bracket)
Self-T
apping Screw
(Not Provided)
#6 x 1
1
∕ 2 "
Hex Head Screw
(Provided)
Longer #6 Hex Head Screw
for Use with Spacer Blocks
(Not Provided)
16
Do Not
Remove
Slat Protector
Tape
Remove Shipping
Protective Piece
Before Installing
Top of Headrail