HunterDouglas LiteRise - Mount the Installation Brackets - Outside Mount

INSTALLATION
7
Mount the Installation Brackets — Outside Mount
To attach the end brackets, a flat vertical surface of at least 1
3
⁄ 4 " is required.
Mark the End Bracket Locations
■
Mark where the ends of the headrail will be located.
➤
Center the headrail over the window opening at the desired height. Use a pencil to
lightly mark each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the
headrail end points over the window opening.
■
Make a second mark
1
⁄ 4 " to the outside of the headrail
end marks. The outer marks are where the outside
edges of the end brackets will be located.
Attach the End Brackets
NOTE: The illustrations in this section show spacer blocks mounted with the end brackets.
Spacer blocks are required for all outside mount 2
1
⁄ 2 " blinds, unless extension brackets are
used. Spacer blocks are optional for 2" slat sizes.
■
Align the outside edge of each end bracket with the outer marks and mark diagonal
screw holes.
➤
Use a
3
⁄ 32 " drill bit to drill holes for the mounting screws.
Mark
Measure and Mark
1
⁄ 4 " Out from
Ends of Headrail
Mark