INSTALLATION
6
■
Use a
3
⁄
32
" drill bit to drill holes for the mounting screws.
■
Attach the end brackets using the screws provided.
IMPORTANT: The front edges of the end brackets must align.
NOTE: For blinds with 2
1
⁄
2
" slats, spacer blocks are used with inside mounts to position
the end brackets a minimum of
3
⁄
8
" away from the glass. The spacing prevents the slats
from rubbing the glass when they are tilted open.
■
Operable Specialty Shapes with sloped headrail: Only the top of each end bracket
can be flush against the casement.
Attach the Intermediate Brackets (If Required)
■
Evenly space the intermediate bracket(s) between the two end brackets.
➤
Adjust spacing if needed to avoid interference with internal headrail mechanisms.
■
Attach the intermediate bracket(s) with two screws through diagonal top holes.
IMPORTANT: The rear of the end brackets and intermediate bracket(s) must align.
Proceed to “Install the Blind” on page 10.
Intermediate
Bracket
End
Bracket
End
Bracket
Space Evenly Space Evenly
To Next Page
Loading...
