Huntleigh Nimbus 3 - Nimbus 3 Professional Mattress and Pump Installation

9
Additional Checks on
the Nimbus 3
Professional Mattress
1. Make sure that all 16 Vent Valves are closed.
2. Make sure that the Head Section Deflate Control is
set to
Dynamic (Normal) Mode.
Installing the Pump 1. If the pump is to be hung from the end of the bed,
make sure that the bed bracket is securely attached
to the pump, and then attach the pump and bed
bracket to the bed frame.
2. Alternatively the pump can be placed underneath
the bed, either upright or lying on its back.
3. Insert the connector on the end of the mains power
cord into a suitable mains power outlet.
Closed Open
Dynamic (Normal) Mode
TriCell Head Section Deflate