Husqvarna 445 - Working Techniques; Pre-Work Safety Checks; Fundamental Safety Rules

English – 23
6.10 Throttle lock, throttle trigger and
return pring  retting
1
Lubricate all pins and mating surfaces with a light
oil.
2
Fit the throttle cable (A), throttle control (B) and
spring (C). (see gure 22)
3
Hold the spring and insert the throttle lock into the
cut-out in the handle. (see gure 23)
4
Check that the throttle cable casing is in the right
position in the petrol tank. Press in the casing until
it stops. (see gure 23)
5
Fit the throttle control pin (E) with the help of a
punch. (see gure 24)
6
Fit the throttle lock (D) by pressing it onto the shaft
in the handle. (see gure 25)
Safety equipment
A
D
C
B
E
D
7
Now loosen the spring.
Cleaning and inspection
• Clean and inspect all parts carefully. If there are
any cracks or other defects replace the dama-
ged parts with new ones. Always use original
parts.
• Check that the spring is not broken and has not
lost its tension.
7
Assemble the handle insert using a screw, when
the throttle control, lever, throttle cable and throttle
control lock with pin are tted correctly. (see gure
25)
Fig 21
Fig 22
Fig 23
Fig 24
Fig 25